Ring Die For Aquatic And Shrimp Feed

Dies-steel mould

FDSP dies are manufactured in the following steels:

■ X46Cr13 (i.e."stainless" steel or "chrome-steel") 

■20MnCr5 (i.e."alloy" steel)

■ 18NiCrMo5 (i.e. similar to 20MnCr·5 but with a higher alloy content).

The X46Cr13 steel dies are vacuum / through hardened. The heat treatment achieves 53-55HRc hardness on the surface and in the core. The high chrome content makes it corrosion resistant. Although it costs more than a normal alloy, X46Cr13 is by far the most common material used through out the feed milling industry.

Pellet ring dies

Pellet Diesmade in 20MnCr5 and18 NiCrMo5 steel, on the other hand, are case hardened to obtain 60-62HRc hardness for approximately 0.8-1.2mm. Under the case hardened layer the steel remains malleable and therefore less brinle. The pellet mill dies made of this steel are more resistant for pelleting extremely difficult fibre-rich products such as beet pulp, alfalfa, straw and hay.

Dies-perfect drilling

FDSP ring dies have an extremely precise and regular perforation: the "honey comb" layout of the holes is faultless.

Deep hole via gun drill drilling: ring die holes array evenly, uniform wall thickness between holes, to ensure ring die works successfully in pellet mill with smooth surface of pellet. It is important to upgrade smooth and polish level of ring die holes in order to decrease temperature difference, lower energy consumption, raise capacity, and reduce loss of nutrition FDSP reach international advanced level relate to hardness of ring die, evenness and smoothness of holes.

Vacuum heat treatment

■ Suitable hardening temperature of vacuum furnace ensures higher hardness and impact toughness.

■ Suitable drawing temperature ensures no cracks of ring dies and little wear of hole and surface, which improves the workinglife.

■ In same loading, adding backfill air pressure will boost die's cooling and hardness.

■ CNC control technology ensures the stability of ring dies.